Zephyr ZML-E42BS Guia de Instalação descarregar pdf (Página 12)

www.zephyronline.com

FRONT

FIG. C

5. Lift support frame assembly up to the ceiling making sure the the word “front” on the top support frame faces the

front of the hood where the controls will be located (FIG. D). The key-holes on the top support frame should cover

the wood screws previously installed in the ceiling. Slide support frame towards narrow end of key-holes to lock

the frame in place.

6. Install the last (2) M6 x 1-1/2” wood screws with washers into the two remaining corners of the top support frame

to secure it to the ceiling. Tighten all screws.

Installation – Mounting the Hood

FIG. D

FIG. E

3. Hood heights between 40” to 50” require lateral support brackets

to be installed to the two top support frame cut off arms and their

corresponding bottom support frame arms. Install lateral support

brackets by (12) M4 x 8 sheet metal screws. (FIG. C)

4. Hood heights between 45” to 50” require a square support bracket

to be installed inside the support frame. Install square support

bracket to top support frame arms by (8) M4 x 8 sheet metal

screws. (FIG. E, #1) Top support frame arms extend past lower

support frame bracket with shorter hood heights. (FIG. E, #2)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Sem comentários

Zephyr ZML-E42BS Guia de Instalação Página 12